|[Home] Technical4-Page 1-10 11 12 13 14 15 16 17 18 19 20 21-30|
|Tip 16 "Direction of flow in glass design"
Certain types of glass have flow in their design or pattern. And, you may want to keep this flow in certain direction (usually horizontal or vertical). I use pencil line method as follows.
Before you cut out design patterns from drawing paper, draw horizontal or vertical (or at any angle if you like) lines LIGHTLY on the design. If necessary, draw marker lines on the glass (in this example, the glass is water glass by SPECTRUM and it is difficult to see the direction so that I draw red marker lines on the glass) Then, when you are marking the paper pattern on the glass, align these lines. Then, cut, tape, position, and solder.