| [Home] Technical4-Page 1-10 11 12 13 14 15 16 17 18 19 20 21-30 | |||||||||||
| Tip 19 Durability of copper-tape stained glass panel A stained glass panel which was made by copper-tape technique was left on the roof of a storage box in 1994. It was placed flat on the roof and never been touched since. And, 15-years later, it was recovered in order to check the surface condition of the panel. Click each photo to enlarge. |
|||||||||||
![]() |
![]() |
![]() |
|||||||||
| It has been left in this position for 15 years. It was never touched since. The temperature gets up to 37 degrees C in summer. | It snows in winter. However, the temperatre only goes down to -5 degrees C. | The surface condition after 15 years. It rained heavily few days before recovery and the surface was fairly clean. | |||||||||
![]() |
![]() |
![]() |
|||||||||
| The panel was turned up side down. The condition of back surface looks very good. | The panel was cleaned thoroughly front and back with a sponge and detergent. | On the front side, the color of lead surface has changed to grey. Beside that, the condition of the panel was relatively good after 15 years. | |||||||||
![]() |
![]() |
![]() |
|||||||||
| Enlarged view of lead surface. Very little patina left. | Condition of back side. Patina is present in good condition except for some small area. | Enlarged view of lead surface of back side. | |||||||||
![]() |
|||||||||||
| Stained glass viewed with light from behind. The glass itself has not been affected and it looks just like new. | |||||||||||